Traditerm^® Cinta Expansión

Composition

Polyurethane foam with acrylic impregnation.
 

Features and applications

• Hermetic sealing of the joints thanks to the foam expansion.
• Sealing against wind, dust and water splashes
• Resistant to temperature changes according to DIN 18542 (BG1), tested from -30 ºC to + 90 ºC.
• Thermal insulation and sound absorber
• Dimensional tolerance leveling.
• Water tightness, vapor permeability.
• UV resistant
   

Instructions for use

• Cut the end of the tape and progressively remove the protective film while placing the tape on the joint
• Apply the compressed joint tape with the adhesive part directly on the protruding element, on the outermost part of the insulating panel, without exceeding the thickness of the insulation.
• Cut the tape at the corners and attach the ends precisely, applying light pressure.
• Installation of the tape and immediate alignment of the insulating panel is recommended.
• In the case of mutually perpendicular joints, the tapes have blunt ends.
• A tight bond can be achieved by leaving one of the tapes approximately 1 cm/m longer than necessary and pressing against the other.
• The sides of the joint, that is, the walls that define the depth of the joint, must be parallel (with a maximum tolerance of 3°)
• The support must be cleaned and loose particles and mortar remains removed.
• Apply the tape at least 2 mm beyond the edge of the joint.
• If the tape is not inserted into the joint for at least 2 mm can, in some cases, change the tape properties and tightness.
• The tape must not come into contact with thinners or aggressive chemicals.

Cautions and recommendations

• Once the tape has expanded its use is not recommended.
• The tape should not be exposed. It must be covered by the coating applied to the panels in a general manner.
• The tape must not come into contact with thinners or aggressive chemicals.
   

Packaging

Roll of 8 m length and 15 mm width.

Store in a dry, covered place and at room temperature (max. 20°C) in the original container.
 

Technical data

(Results obtained in the laboratory under standard conditions)

Note

The instructions for use are given according to our tests and knowledge and do not imply any commitment by GRUPO PUMA nor free the consumer from the examination and verification of the products for their correct use. Claims must be accompanied by the original packaging to allow a proper traceability.

GRUPO PUMA is not responsible, in any case, for the application of its products or constructive solutions carried out by the application company or other parties involved in the process and / or execution of the work, limiting the responsibility of GRUPO PUMA exclusively to the damages directly attributable to the supplied products, individually or integrated in systems, due to failures in their manufacturing process. In any case, the drafter of the work project, the technical management or the person responsible for the work, or collaterally the application company or other parties involved in the process and / or execution of the work, must ensure the suitability of the products addressing the characteristics of them, as well as the conditions, support and possible pathologies of the work in question.

The values obtained by GRUPO PUMAS's products or its constructive solutions that, as the case may be, are determined by the EN standards or any other regulation that applies to it in each case refers exclusively to the conditions specifically stipulated in said regulation and that are referred to, among others, to certain characteristics of the support, humidity and temperature conditions, etc. without being them required in the tests obtained under different conditions, all in accordance with the relevant regulation