Paviland^® Top EP

Composition

An epoxy resin and polyamide-based product.

Features and applications

• Exceptional adhesion to the substrate. High resistance to abrasion.
• Very good chemical resistance to fuels, oils, greases, acids, etc. 
• Easy to mix and apply.
• Prolonged application time. 
• Surface hardener of the substrate. Industrial floors and warehouses.
• Garages.
• Laboratories.
• Chemical products factories.
• Hygienic cleaning: non-porous surfaces which are easy to clean.
   

Substrates

• Concrete or suitably durable self-levelling cement (minimum pressure resistance of 25 N/mm2 and traction of 1.5 N/mm2), slightly rough with open pores. For other base materials, please contact our technical department.
• All base materials must be durable, stable, sound and clean, in addition to being free of dust, form release agents (e.g. paint stripper), organic products, etc. 
• Prior to application, any imperfections and/or cracks that may be present in the base materials should be suitably repaired using our range of PAVILAND or MORCEM REST products.
• Milling and/or sanding of the base material is recommended in order to open the pores and de-scale bonded materials, such as grease, paint, etc.
• The base material must be completely dry and the concrete sufficiently matured, with a residual moisture level lower than 3%.

Instructions for use

• Mix the separate A and B components.
• Empty component B onto component A and mix with an appropriate high-speed mixer until a uniform consistency has been obtained, subsequently adding the percentage of solvent specified below.
• Different percentages of EP PUMA SOLVENT should be added depending on the mode of application. Airless spraying: 2–5%. Air-spraying (spray gun): 10 – 15%. Brush: 10%. Roller: 5 %.
• Allow the mixture to settle for 5 minutes before using.
• Apply the first coat with a brush, short-haired roller, spray gun or airless sprayer. 
• The second coat, at the previously-mentioned solvent percentage, should be applied 24–48 hours afterwards. Please note that these time periods are guidelines and may vary depending on the ambient temperature.
• The overall finish must be smooth and uniform. Irregular application of different product thicknesses may cause variations in the overall tone and appearance of the surface.
• Make sure the surface remains protected for at least 48 hours following application.

Cautions and recommendations

• Do not apply the product under 10º due to the potential resin crystallization.
• Do not apply it above 30ºC.
• Do not apply under the risk of frost, rain, heavy wind or direct sun light.
• Use gloves and protective goggles when manipulating the product. In case of direct skin or clothes contact, clean the area with abundant water.
• Keep away from children.
• The substrate must be dry (less than 3% humidity).
• The product changes tone or may experience discolouration when used outdoors or exposed to UV radiation; hence, it is recommended for indoor use only.
• Low temperatures or intervals exceeding 48 hours between coats can cause coverage issues between coats.
• Any equipment and tools will be cleaned with water immediately after being used. Once the product gets hard, it will only be removed by mechanical means.
• It is necessary to always maintain proper ventilation in the application area. 
• Do not eat or smoke when manipulating the product.
• Empty containers should be removed or thrown according to the current legislation.
• As a consequence of the change in raw materials, the shades of the coloured mortars may vary slightly by batch.

Packaging

Colour range

Technical data

(Statistical results obtained under standard conditions).

Time of application

Timings are given according to temperatures of 23ºC and 55% relative humidity. Periods of time will be shorter at higher temperatures and longer at lower temperatures.

Note